Spare Parts for Modular Holder
Category:
Hardware 100mm
Back Plate
The Back Plate is the essential part of the holder. This item will allow you to screw in the Spring & Plain Spacer to being creating your holder.
Aluminium Back Plate
The Back Plate is the essential part of the holder. This item will allow you to screw in the Spring & Plain Spacer to being creating your holder.
Brass Clamp Screw
The Brass Clamping Screw is used to tighten the holder in place, once attached to the adaptor ring on your lens. By tightening and loosening this screw, you can rotate the holder to ensure your grad line is positioned correctly.
Spring Spacer
Additional Spring Spacers can be purchased to allow you to use extra filters, or as replacement parts for your existing set up. Made from lightweight Nylon, these are attached to the holder using the Long & Short Brass Screws. Sold as a pair.
Plain Spacer
Additional Plain Spacers can be used to modify the Spring Spacers to take 4mm Glass Filters. This means that a whole new range of filters become available to the Hitech Filter System user (such as the Hot Mirror filters). Made from lightweight Nylon, these are attached to the holder using the Long & Short Brass Screws. Sold as a pair.
Brass Screws (Long/Short)
Solid Brass Screw. Available in Short (for wide angle shots, to avoid vignetting) & Long (when using maximum numbers of slots & Threaded Ring). Sold individually.
Brass Insert (Nut)
Brass Inserts (also known as Nuts) are used to secure the Spring & Plain spacers to the Back Plate. Sold individually.
Clamp Ring
The Clamp Ring is used to allow the adapter rings to fit neatly into the Back Plate.