Modular Filter Holder - Complete
Category:
Hardware 100mm
The basic set up for your modular holder.
Contains
1 x Back Plate
1 x Brass Clamp Screw
6 x Brass Screw (in both Long & Short versions)
6 x Brass Nuts (Insert)
6 x Spring Nylon Spacers (to allow you to create 3 filter slots)
2 x Plain Spacers (to allow you to extend one filter slot to accommodate 4mm filters)
By purchasing this system, you will be able to create a three slot holder. One of these slots can then be modified to hold a 4mm glass filter, by inserting the plain spacers.
Additional Spring & Plain Spacers can be purchased, as well as a Threaded Ring to utilise the holder to its maximum ability. Additional screws & nuts can also be purchased if required.
Assembly instructions
For 4mm Glass Filters
Insert two brass screws into one side of the Back Plate. Take the Plain Spacer, and thread this onto the screws. Next, take a Spring Spacer and thread this onto the screws. Continue to thread Plain (extra spacers are sold separately) and Spring Spacers onto the screws until you reach the required number of slots. Finally, screw the Brass Inserts (Nuts) onto the screws & tighten to secure the slots in place. Repeat on the other side. Your holder is now ready to use.
For Hitech Filters
Insert the two brass screws into one side of the Back Plate. Take the Spring Spacer and thread onto the screws. Repeat until required numbers of slots have been created. Finally, screw the Brass Inserts (Nuts) onto the screws & tighten to secure the slots in place. Repeat on the other side. Your holder is now ready to use.
Please note that for your convenience, this holder will come fully assembled.